Dear Mike: I'm not familiar with your keyboard, but is it does have slots for a stand, consider the following:
Music Stands generally are supplied in two styles, Plastic Panel or Rod. When they are not readily available from manufacturers, you might consider making a simple one yourself from 3/16 diameter Iron or Copper Rod, or have a local workshop custom make one.
Your Keyboard has either two support Slots or two support Holes into which the Stand fits. The 3/16 diameter of this proposed Stand should fit into either type of Keyboard support aperture.
The Rod used should be approximately 29 long, including a 14 Top and two 71/2 Arms. (71/2 from each end of the Rod make bends to form a straight-topped U).
About 1 from the Rod ends, bend them backwards about 300 in the same direction. This will eventually produce the incline for the Sheet Music. As an option, a 2 Ledge can be epoxied to the front at the point just above the bends.
Before rushing into production visualize, read and clearly understand these instructions. Good luck!
Oct 05, 2009 Rating
I have a stand by: Anonymous
Hi! I have a stand that came with my P150 but it doesn't fit anymore because the slot has a bump in it.
Would you like it? email me at zbram@rogers.com
